
Also works: Calves · Hamstrings · Quadriceps
From tall kneeling, you sit back onto your heels and then jump hard enough with the hips alone to land on your feet in a squat. Removing the ankles and knees from the equation makes this an almost pure test of how fast the glutes can fire, and it is unforgiving of anyone who cannot.
Set up first, then execute. Every cue below is something you can check on your next set.
Breathing & tempo — One breath per rep: inhale and brace tall, hold through the sit-back, and exhale on the snap. Fast down, faster up, no tempo on the landing beyond absorbing it softly.
Where to start, and what to change when it stops being hard.
Bodyweight is the correct load for almost everyone, and for many it stays that way. If you progress, start at 20 kg — an empty bar — and add 5 kg at a time only while every rep still lands flat-footed with hips through. Height off the floor and quiet landings are the markers; if either degrades, the previous weight was your ceiling.
The errors that show up most often, and the cue that fixes each one.
Keep the ribcage stacked over the pelvis for the whole rep and drive the hips forward, not the head. Film one set from the side — the torso angle should barely change.
Aim to land whole-foot with your knees over your mid-foot. If you cannot, jump less far forward and higher instead, or drop the load entirely.
Earn 5 consecutive bodyweight reps landing flat and quiet before you rack anything. Load buys you nothing here if the catch is already late.
Cap sets at 3-5 reps with 60-120 seconds rest. Once you stop leaving the floor cleanly, the set is finished regardless of what the program says.
Kneeling deletes the ankle joint and shortens the range at the knee, so the only engine left is hip extension. In a standing jump you can hide a lazy hip behind calf and quad drive; here, if the glutes do not snap, you simply do not leave the floor. That is the diagnostic value of the movement.
The landing is what makes it demanding rather than novel. You have a fraction of a second to swing your shins under you and catch bodyweight on your feet in a partial squat. Time it late and you land on your toes with your hips behind you, which is both ineffective and how people tweak knees on this drill.
It is filed under olympic weightlifting because lifters use it to train hip snap for the clean and snatch, and it belongs in the same slot: right after the warm-up, before anything heavy, in sets of 3-5 with a full minute or more between them. It is technique and speed work, never a finisher.
No kit, too hard, or too easy — here's where to go instead.
No, and most people should not use one. The value is in the speed of hip extension, and bodyweight already exposes whether that speed exists. A bar mainly adds risk to a landing that is already the technical bottleneck.
It can, because the second pull of a clean is exactly this: a violent hip extension followed by pulling yourself under a moving object. It will not fix a bad first pull or a slow turnover, so treat it as one accessory, not a substitute for pulling from the floor.
First check the surface — most complaints are contact pain from a thin mat, solved with a folded towel or a proper pad. If the pain is inside the joint on landing, you are catching late and loading a nearly straight leg. Stop and rebuild with kneeling squats until the catch is reliable.
Once or twice a week, fresh, at low volume. Ten to twenty quality reps per session is plenty. Like any jump, fatigued reps carry the joint stress without producing the speed adaptation you came for.