All exercises
Cable Hip Adduction
Legs

Cable Hip Adduction

QuadricepsCable
beginner · isolation · strength

A standing single-leg cable drill: an ankle cuff on a low pulley drags one leg out to the side, and you pull it back across the midline against the stack. It loads the adductor group directly through a long range, which almost nothing else in a normal leg session does.

How to

Own the movement

Set up first, then execute. Every cue below is something you can check on your next set.

Before the first rep

  • Set the pulley at the lowest pin and strap the ankle cuff around the leg nearest the stack, just above the ankle bone.
  • Stand side-on and step away until the cable is already taut with the working leg pulled out to the side.
  • Hold the machine frame or upright with the near hand — this is a leg exercise, not a balance test.
  • Stand tall on the far leg with a soft knee and the hip stacked over the ankle.
  • Start light enough that the stack does not drag your standing foot sideways when you let it out.

Every rep

01
Pull the working leg across the front of the standing leg, leading with the inner thigh rather than swinging from the foot.
02
Keep the working knee straight and the toes pointing forward the whole way — rotating the foot turns this into a hip flexor drill.
03
Finish when the working foot passes the midline. Extra travel comes from the pelvis, not the adductors.
04
Let the cable pull the leg back out slowly over about three seconds — that eccentric is the useful half.
05
Keep the standing hip level. If your pelvis tips or your torso leans away, the weight is too heavy.

Breathing & tempo — Exhale as the leg crosses the midline, inhale as the cable takes it back out. One second in, one-second squeeze, three seconds out.

Before you load it

  • If you have a history of groin strain, build the range up over several sessions rather than starting at full stretch — the far end of the range is exactly where adductors tear.
Programming

Sets, reps & load

Where to start, and what to change when it stops being hard.

Strength
3-4 sets of 8-10 per leg
Hypertrophy
3-4 sets of 12-15 per leg
Endurance
2-3 sets of 20 per leg

Start on the lightest two plates of the stack — most people can adduct far less than they assume, and a heavy stack will simply pull you off the standing foot. Progress when you can complete 15 controlled reps per leg with a level pelvis and no torso lean; add one plate rather than more reps.

Fix your form

What goes wrong

The errors that show up most often, and the cue that fixes each one.

Swinging the leg across with momentum and letting it snap back out.

Halve the weight and set a 1-second squeeze at the midline with a 3-second return. If the plate slaps the stack on the way back, it is not under control.

Leaning the torso away from the machine to counterbalance the load.

Grip the upright and keep your shoulders stacked over the standing foot. Reduce the load until you can keep your ribcage vertical for every rep.

Turning the working foot out so the hip flexors take over.

Point the toes straight ahead and imagine sweeping the inner ankle bone across the floor. The line of pull should stay purely side to side.

Treating it as spot reduction for the inner thigh.

Train it for adductor strength and log it as such. Where you lose fat is decided by your overall energy balance, not by which muscle you contract.

The case for it

Why bother

The adductor magnus is one of the largest muscles in the lower body and a serious hip extensor, yet it only ever gets trained as a bystander in squats and lunges. A cable cuff on the ankle gives it a resistance line it actually opposes: the pulley pulls the leg away from the midline, and adduction is the only way back.

Groin strains happen at long muscle lengths, when the leg is out wide and being asked to brake. Because the cable holds tension at the far end of the range rather than at the top, this is one of the few gym movements that loads the adductors where they usually fail. Upstream databases file this under quadriceps; that is simply wrong, and you should feel it high on the inner thigh.

Where it fits

Accessory work at the end of a lower-body day, or on an upper-body day if your knees need a break from squatting. Two or three sets per leg, twice a week, is enough. It pairs badly with heavy squats immediately afterwards — tired adductors let the knees drift in.

Swap it out

If this one isn't it

No kit, too hard, or too easy — here's where to go instead.

Questions

Asked and answered

Will this slim down my inner thighs?

No. You cannot choose where fat comes off, and no amount of adduction work will change the fat layer over the muscle beneath it. What it will do is make the adductors stronger and more tolerant of long-range loading, which matters for squat depth and for anyone who plays a sport with cutting and lateral steps.

Is this better than the seated adductor machine?

For most purposes, yes. The seated machine trains adduction with the hip flexed and your torso supported; the cable version trains it standing, on one leg, with the pelvis having to stay level. That is closer to how the adductors work when you push off sideways. The seated machine wins only when you want more absolute load.

Do I need this if I already squat and lunge?

If you squat wide and deep, your adductors get a decent share of the work. Add this when you have a specific reason: a previous groin strain, knees that cave under load, or a sport with repeated lateral pushes. As general leg development it is a low priority next to squatting.

Why does the upstream description say quadriceps?

Because the exercise database it came from mislabels this one, and also uses the word abduct where it means adduct. Pulling the leg toward and across the midline is adduction, and the muscles doing it are the adductor longus, brevis, magnus, gracilis and pectineus. If you feel this in the front of your thigh, your foot has rotated out.

Enough theory.
Go log a set.